These 1 GPH pressure compensated drippers are used to keep a constant flow of 1 GPH at various water pressures up to 25 PSI

A 25 PSI pressure regulator MLA-25PR and a filter MLFF-41 are highly recommended to be used first at the water source when using these 1 GPH drippers

Use this dripper to slowly water a potted plant or landscapes using only 1 GPH of water and they are ergonomically designed with a wide-winged top to make the installation easier

The water supply enters into the dripper from the barbed end and then the water is dispersed from the stem end

Install these drippers directly into the 1/2-in poly tubing by first snapping a hole using either of our punch tools MLA-51 or MLA-TOOL and use our goof plugs MLA-51G if you snap a hole in the wrong place or want to relocate the dripper

These drippers can also be installed by running a piece of 1/4-in vinyl tubing to the plant from the 1/2-in poly tubing using the 1/4-in barbed couplers MLT-BXB then by pushing in the dripper at the other end of the 1/4-in vinyl next to the plant

Our 1/4-in support stakes MLT-DST can be used to securely hold the 1/4-in vinyl and 1 GPH dripper near the plant

Also use our 1/4-in tees and elbows MLT-ATE to run the 1/4-in vinyl in opposing directions or in tight corners to supply water to these drippers

With a beginning water pressure of 25 PSI you can run 500-ft of our 1/2-in poly tubing and install up to 250 of these 1 GPH PC drippers