Use this fitting when attaching our 1/2-in poly tubing to run a water supply to micro- or drip-irrigation off an existing underground irrigation system

Ergonomically designed to make installation easier and to create a secure fit based on your hand strength

Use the 1/2-in male pipe thread side to attach to a 1/2-in female pipe threaded fitting that is attached to the underground-sprinkler system

Attach the 1/2-in poly tubing by first pushing back the locking collar to expose the barb with a built in O-ring

Push and wiggle the 1/2-in poly onto the fitting and under the collar until snug

While holding the tubing with 1 hand turn the ears of the collar in a left counter-clockwise motion to tightened and lock onto the 1/2-in poly tubing

This fitting can be uninstalled easily by unthreading the collar in a clockwise motion then by pulling off the 1/2-in poly

This fitting works with 1/2-in poly tubing that has an inside dimension of 0.600-in ID and an outside dimensions of 0.700-in OD

Proudly made in the USA